CompuLab SBC-X270 Manual do Utilizador descarregar pdf (Página 28)

SCIOPTA - Real-Time Kernel

3-4 Manual Version 4.1 User’s Manual

SCIOPTA - Real-Time Kernel

3 Getting Started

31. Launch your source-level emulator/debugger and load the resulting sciopta.elf.

32. If you have connected a serial line from the COM port of your host PC to the UART of your target board, open

a terminal window on your PC and connect it to your selected PC COM port. Parameters are 115200Bd, 8 Bit,

no parity, 1 stop bit, no flow-control.

33. For some emulators/debuggers specific project and board initialization files can be found in the created project

folder or in other example directories.

34. Now you can start the system and check the log messages on your host terminal window.

35. You can also set breakpoints anywhere in the example system and watch the behaviour.

3.3.3 Please Note

• Study carefully the makefile to get a good understanding of the whole build process and the needed files in a

specific SCIOPTA project.

• The makefile calls the SCIOPTA configuration utility directly (command line version, see chapter 16.19 “Com-

mand Line Version” on page 16-33). In a standard project you will rather use the normal GUI version as the

utility is not used very often and you should not directly edit the sconf.xml file.

• The V=1 switch in the build call is just used to show you the full build information.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 225 226

CompuLab SBC-X270 Manual do Utilizador Página 28